Operation definition

From PlcWiki

Revision as of 15:04, 15 February 2011

Each operation needs to be defined by its index and type. All other parameters are optional, but some of them are necessary for a valuable operation definition:

Operation.name.Type = <Operation type>
Operation.name.Index = <Operation index>

for example:
Operation.AirbagSN.Type = Serial
Operation.AirbagSN.Index = 2

A parameter name joins all operation parameters together.

Operation type can be one of the following ones:

SequenceCheck
ProductConfiguration
LastWPCheck
Serial
PartCheck
PartCode
CableCheck (Poka-Yoke Check)
Tightening
VisualCheck
OutputCheckCorrection
OutputCheck
PidWrite
ixpioSignal
VisionSensor
PreSequence
Measurement
RackPartCheck
BlindAudit
SerialInput

Operation parameters

The conveyor can be stopped in case of NOK result of the operation

(bool) Operation.name.SendConveyorStopWhenNOk

The product can be sent automatically to a rework procedure using this parameter:

(bool) Operation.name.SendToReworkWhenNOk

(bool) Operation.name.InvalidLabelAllowed = Yes | No
For safety critical operations like VW baugruppen it should be set to "No". Then the control bar code "Invalid label" (PLCIL) is not accepted.
The logic is, that a product without safety critical documented items is not cempletely assembled and should not be released to the customer.
If it is not possible to scan the part label, the part needs to be changed to the correct one. So then it is necessary to assemble another
piece or sent the product to a rework station.