PLC workstation installation

From PlcWiki

Revision as of 12:54, 6 May 2010

PLC workstation installation process

This article describes installation of PLC workstation using automated installation process. This installation process uses kickstart script and RPM repository for client installation. Installation steps follows.

• Installation preparation

Kickstart script generation

There is script on kernel which generates kickstart script for PLC station being installed. Run

/var/ftp/gen_kickstart <WPID> <LAST_IP_NUM>

WPID - workplace ID

LAST_IP_NUM - last number (octet) from IP address

Example:

We will install workplace A1, IP address will be 10.1.1.25. To generate kickstart script run:

/var/ftp/gen_kickstart A1 25

• PLC client configuration preparation

This is an optional step. You can prepare clients' configuration. You have to copy a configuration file to a directory on kernel. All prepared configurations has to be copied to the directory /usr/local/plc/workstations/XX/etc, where XX is a workplace ID. It is possible to add other files to XX directory and its subdirectories.

Subdirectories:

etc - configuration files

bin - binary files

Content of these directories will overwrite default content from an installation.

• Installation

There are several installation media. Mostly used is an USB flash disk. If there is a problem with a booting from a USB flash, it is possible to boot from a CDROM. For an installation media creation contact PLC support.

Boot from installation media. Boot menu will look similar like this:

Press TAB to edit boot parameters, add these parameters:

gateway=<GATEWAY> netmask=<NETMASK> dns=<DNS> ks=ftp://<KERNEL_IP>/<WPID> ip=<INSTALL_IP>

• <GATEWAY> gateway of your network
• <NETMASK> mask of your network
• <DNS> coma separated list of DNS servers (IP addresses)
• <KERNEL_IP> IP of your PLC kernel
• <WPID> workplace id (name of kick start script)
• <INSTALL_IP> IP address which will be used during installation

Boot.

Rest of installation should be automatic.